- This topic has 8 replies, 4 voices, and was last updated 19 years ago by
.
-
Posts
-
Heating’s been foobarred since before christmas. Managed to get it running by running hot water on constant and turning it on full. (water is now scalding hot – not good with kids in the house)
I think a valve is sticking but I’m not sure which one.
any ideas?
BTW – It’s a 2 zone system (upstairs/downstairs) with a glow-worm boiler. Thermostats are working ok and I think the Grundos 15/60 3 speed pump is working OK too (thank fook for heating forums)
Merry fookin Chrimbo !
shivers
*Update*
After a few hours and a lot of googling I have found the problem!! (YaY!)
It’s a zone actuator valve. Well the actuator not the valve
just gotta find somebody to fit it now ๐ฅ
Will phone plumbers tomorrow
Actuator is just a small stepping motor you can do it your self, just get the same one you have fitted ๐
@=XDC=sPUNKer wrote:
anything cheaper than a plumber FTW ๐
For sure !! รฦรโรยขรขโยฌร ยกรฦรขโฌลกรโรยฃ43.00 for the parts – Job Done!!
runs off for a bath!
@=XDC= MadHippy wrote:
runs off for a bath!
Well why did you not buy one when you were at the plumb centre ๐
@XDC-snell wrote:
@=XDC= MadHippy wrote:
runs off for a bath!
Well why did you not buy one when you were at the plumb centre ๐
The man has a point โ ๐ ๐
- You must be logged in to reply to this topic.